charlie's flybox

Letort Hopper


Fly Patterns brought to you by Charlie's FlyBox
© All images, slogans and content are strictly copyrighted and may not be used or copied
without permission.
Charlie Craven and Charlie's FlyBox, Inc.
print this page

step: 1
Pattern Description
The little Letort Hopper from Ed Shenk is one of the easiest hopper patterns to tie and one that many tyers cut their terrestrial teeth on. Using just a few commonly available materials, the Letort can cross over for small hoppers as well as caddis and stoneflies.
Materials Needed:

Letort Hopper>>>>>>>>>>> Hook: TMC 100SP-BL #10-16>>>>> Thread: Yellow 3/0 Monocord>>>>> Abdomen: Pale Yellow Dubbing>>>>> Wing: Turkey Wing Fibers, coated with vinyl cement>>>>> Collar and Head: Natural Deer hair
step: 2
Start the thread and wrap back to the bend of the hook. charlie's flybox
charlies flybox
step: 3
Dub the body from the bend up to about the 75 percent point. You want a clean shoulder at the front of the body and the body itself should be relatively thick. charlie's flybox
charlies flybox
step: 4
Clip a coated section of turkey wing fibers and trim the butt end to a point. This slip should be about 2/3rd as wide at the hook gap. To coat the feathers, use a flexible cement such as Dave'sFlexament or Wapsi's Vinyl Cement to coat the fibers from the butts to the tips. Be sure to allow adequate drying time as they remain sticky for about an hout or so after coating. charlie's flybox
charlies flybox
step: 5
Lay the slip on top of the hook with the tip extending just beyond the bend. Tie the slip in place with a couple firm wraps of thread. charlie's flybox
charlies flybox
step: 6
Clip the excess turkey slip close to the hook shank on the front. Build a thread base to the eye and back to the base of the body. charlie's flybox
charlies flybox
step: 7
Cut, clean and stack a clump of deer hair. Measure the tips against the hook so they are about a shank length long. Clip the butt ends a bit so they have square ends. charlie's flybox
charlies flybox
step: 8
Hold the clump of hair above the hook with the butt ends sticking out past the hook eye. charlie's flybox
charlies flybox
step: 9
Put two three soft turns of thread over the hair at the front of the abdomen. charlie's flybox
charlies flybox
step: 10
Pull the thread toward you and slightly back to flare the butt ends. Wrap the thread forward through the butt ends of the hair to the front of the clump. charlie's flybox
charlies flybox
step: 11
Cut and clean another bunch of hair and clip the tips off. Place this clump of hair on the hook from the front with the center of the clump even with the front of the first bunch. charlie's flybox
charlies flybox
step: 12
Put three turns around this clump and spin it on the hook. charlie's flybox
charlies flybox
step: 13
Work the thread forward through the hair to the eye and whip finish the thread. charlie's flybox
charlies flybox
step: 14
Use a razor blade to trim the head into a square shape as shown here. Leave the natural tips on top to form the collar. charlie's flybox
charlies flybox