charlie's flybox

Z-wing Caddis


Fly Patterns brought to you by Charlie's FlyBox
© All images, slogans and content are strictly copyrighted and may not be used or copied
without permission.
Charlie Craven and Charlie's FlyBox, Inc.
print this page

step: 1
Pattern Description
The Z-Wing Caddis comes from the vise of the illustrious Mike Mercer. This little bead head caddis pupae pattern makes a great dropper under a dry and draws strikes all the way through the water column. I like this pattern for its ease of tying and the simple material list. This is a killer in a size 18 or 20, and is so simple that even in small sizes its still an easy tie. Color options run the gamut, but mint green, olive and cream/tan are all favorites. Go tie.
Materials Needed:

Hook: TMC 2457 or 2487 #12-20 Bead: Copper colored brass or tungsten, sized to hook Thread: 8/0 or 10/0 Olive Rib: Chartreuse wire or 3/0 tying thread Shellback: Turkey Tail Quill Abdomen: Antron Dubbing, mint in color Wingstubs: Ginger Z-Lon Head: Peacock Herl
step: 2
Place bead on the hook and start the thread behind it. Wrap a thread base from the seventy-five percent point to about halfway down the bend and back again. charlie's flybox
charlies flybox
step: 3
Tie in a six-inch length of wire for the rib at the 75% point on the FAR SIDE of the hook. charlie's flybox
charlies flybox
step: 4
Wrap back over the wire with the tying thread to the end of the thread base and return the thread back to the front. Make sure to keep the wire along the far side of the hook as you wrap back over it. charlie's flybox
charlies flybox
step: 5
Cut a slip from the turkey tail quill that is, at its tip, about half as wide as the hook gap. charlie's flybox
charlies flybox
step: 6
Cut the tip of the quill slip square across and tie it in with the inside of the feather facing up at the center of the shank with one or two turns of thread. Try to get the slip to buckle around the hook shank, rather than roll up into a bundle on top of the hook. charlie's flybox
charlies flybox
step: 7
Pull the butt end of the feather to shorten the tip down to length. You want to use the natural taper of the feather slip to create the tapered shell back, so bring the tip all the way back to the thread. charlie's flybox
charlies flybox
step: 8
Wrap back over the quill slip to the bend of the hook. Return the thread to the front once more. charlie's flybox
charlies flybox
step: 9
Dub a tapered abdomen with the antron dubbing from the bend of the hook to the seventy-five percent point. charlie's flybox
charlies flybox
step: 10
Pull the turkey slip forward over the top of the dubbed abdomen, but keep it a little to the near side of the hook. Don't pull the slip too tight, youll need a little slack in it when you rib. Just a little slack... charlie's flybox
charlies flybox
step: 11
Tie the quill slip down at the front of the abdomen. Again, try to keep the slip slightly off-center toward the near side for the time being. charlie's flybox
charlies flybox
step: 12
Spiral wrap the ribbing in evenly spaced turns over the quill slip. When you do this, the rib will pull the quill slip to top dead center on the body. If we hadn't tied the slip in off-center, it would now be pushed to the far side rather than the top. Tricky... charlie's flybox
charlies flybox
step: 13
Clip the stub end of the wire and the turkey slip off flush. Try to keep the slip from splitting like this one did. You could coat the feather with Flexament beforehand, but it really doesn't matter to the fish. charlie's flybox
charlies flybox
step: 14
Separate a strand of Z-Lon so you have about two thirds of a strand that is about two inches long. Tie the Z-Lon in at the front of the body at the center of its length, with one side of the strand pointing back along the body on the far side. charlie's flybox
charlies flybox
step: 15
Pull the other end of the Z-Lon strand back along the near side and secure it in place with a few more wraps of thread. charlie's flybox
charlies flybox
step: 16
Select a bundle of peacock herl and trim the tips so they are even. Tie the peacock in by the tips at the back edge of the bead. Make several wraps of thread to build up a bit of bulk behind the bead. charlie's flybox
charlies flybox
step: 17
Wrap the peacock forward with three or four turns and tie it off behind the bead. Clip the excess peacock. charlie's flybox
charlies flybox
step: 18
Whip finish the thread right behind the bead and trim the thread. charlie's flybox
charlies flybox
step: 19
Trim the wingstubs at about the halfway point on the hook shank. charlie's flybox
charlies flybox
step: 20
Finished Fly, top view. Note the angle of the wingstubs and the taper of the body. charlie's flybox
charlies flybox
step: 21
Finished fly, bottom view. Notice the two-tone effect created by the lighter dubbing and the turkey slip shellback. charlie's flybox
charlies flybox
step: 22
Finished fly, side view. charlie's flybox
charlies flybox